Description

If your old Ford tractor has been puffing smoke, burning oil, or just doesn’t have the power it used to, it’s time for a rebuild. These classic tractors were built to last, but after decades of faithful service, even the toughest engines need some attention. This basic overhaul kit gives you the essentials to bring your 4-cylinder gas engine back to life without breaking the bank.

What You’re Getting

Thin wall (.040 inch) cast sleeves that restore proper cylinder dimensions
3-ring autothermic pistons designed to handle the heat and pressure of farm work
Complete ring sets that seal properly and reduce oil consumption
Full gasket set with crankshaft seals to stop leaks at every joint
Pin bushings to eliminate wrist pin knock and restore smooth operation

Built for Real Farm Work

This kit fits the 4-cylinder 119.7 cubic inch gas engine found in Ford 9N, 2N, and 8N tractors—the workhorses that built American agriculture. Whether you’re using your tractor for loader work, bush hogging, or light tillage, these engines were designed to run all day at governed RPM and keep coming back for more.

Made to Last

The Tru-Power components in this kit are built to handle the demands of real farm use. The thin-wall sleeves provide excellent heat transfer, while the autothermic pistons are designed to expand properly as they warm up, maintaining good ring seal even under varying load conditions.

Good to Know

This is a basic kit that doesn’t include bearings, so you’ll need to check your rod and main bearings separately. The .040 inch sleeve design is what Ford used from the factory, so installation is straightforward for any mechanic familiar with these engines. A good tip: while you’ve got everything apart, it’s smart to check your valves and guides too.