Headlamp Rubber Mounting Set for Deutz 06 Series Tractors – 6-Piece Anti-Vibration Kit

Description

Those rattling, loose headlights on your Deutz aren’t just annoying—they’re breaking filaments and leaving you in the dark when you need light most. This 6-piece rubber mounting kit brings back that solid, vibration-free headlamp mounting your tractor had when new. No more jiggling beams while trying to hook up equipment in the dark or watching your lights bounce around like disco balls going down rough roads.

What You’re Getting

• Complete 6-piece set provides all rubber mounts needed for both headlamps
• Direct replacement for worn mounts—fits right where the originals go
• Absorbs vibration to prevent premature bulb failure and extend headlight life
• Weather-resistant rubber compound won’t crack or deteriorate like old mounts
• Restores steady beam pattern for safer operation in low-light conditions

Built for Real Farm Work

Your Deutz 06 series is built tough for serious farm work—whether it’s your 6806 pulling tillage equipment, a 5206 on loader duty, or that trusty 6130 that does a bit of everything. But all that power creates vibration, and vibration is death to headlight bulbs. These rubber mounts isolate your headlamps from the constant shaking, keeping your light beam steady instead of bouncing around.

Made to Last

After years of engine vibration, temperature swings, and weather exposure, those original rubber mounts turn hard as rocks or crumble into pieces. This replacement set uses modern rubber compounds that stay flexible in freezing weather yet won’t turn to goo in summer heat. The 6-piece set means you can replace all the mounts at once—because if one’s bad, the others aren’t far behind.

Good to Know

Installing these rubber mounts is a 20-minute job that’ll save hours of frustration. Remove your headlamp assemblies carefully—the mounting bolts often hide behind the lamp housing. Clean out any old rubber pieces from the mounting points; they tend to leave chunks behind. Make sure each mount is properly seated before tightening to avoid stress cracks in lamp housings.