Twin Point Combine Sickle Section for John Deere and Hesston Combines

Description

When harvest time rolls around and your combine’s cutting performance starts to fall off, worn sickle sections are usually the culprit. You’ll notice it first in tough or lodged crops—stems getting pushed instead of cut, leaving ragged stubble behind. This twin point sickle section from Kondex gets your machine back to slicing through crops like it should, keeping your harvest moving at the pace you need.

What You’re Getting

• Twin point design with two cutting edges for better performance in thick or tangled crops
• Fine serrated edge with 14 teeth per inch for clean cutting action that doesn’t tear or push stems
• Extra heavy construction and plated finish that stands up to rocks, dirt, and the punishment of long harvest days
• Direct bolt-on replacement with standard 7/32 inch fastener holes on 2.063 inch spacing
• 3-1/4 inch length and 3 inch width sized for proper overlap and smooth cutting action

Built for Real Farm Work

This section is engineered for John Deere and Hesston combines working in corn, soybeans, wheat, and other grain crops. The twin point configuration gives you two sharp edges working together, which means cleaner cuts and less plugging when you’re dealing with down corn or tangled bean stems.

Made to Last

Kondex builds these sections with extra heavy steel and a protective plated finish that resists wear and corrosion. The fine serrations stay sharp longer than smooth sections, and the twin points distribute the cutting load so you get more acres out of each section before replacement.

Good to Know

These sections install with standard sickle bar bolts—no special tools or modifications needed. When replacing sections, it’s smart to do the whole bar at once for even cutting performance. Keep a few spares on hand during harvest, especially if you’re cutting in rocky or abrasive conditions.