Description
When you’ve got a split or cracked hose that’s keeping you from finishing the job, this brass hose mender gets you back to work fast. Instead of replacing an entire length of expensive hydraulic or water hose, you can cut out the bad section and splice it back together with this sturdy fitting. It’s the kind of repair that’ll hold up season after season, saving you time and money when equipment breaks down in the field.
What You’re Getting
- Solid brass construction that won’t crack or corrode like plastic fittings
- Barbed ends grip tight inside the hose for a leak-free connection
- 1/2-inch size works with common hydraulic, air, and water hoses
- Easy field repair – just cut out the damage and clamp this in place
Built for Real Farm Work
This mender handles the pressures and conditions you’ll find on tractors, implements, and shop equipment. Whether it’s a hydraulic line on your loader, a water hose for the sprayer, or an air line in the shop, this fitting does the job. The 1/2-inch size is one of the most common hose diameters you’ll run into on farm equipment.
Made to Last
Brass doesn’t rust, crack in cold weather, or get brittle from chemicals and UV exposure like plastic alternatives. The barbed design creates a mechanical grip inside the hose that won’t work loose under pressure or vibration. This is the same type of fitting hydraulic shops use for permanent repairs.
Good to Know
Cut the damaged section out with a sharp knife for clean, square ends. Slide hose clamps over each end before pushing the hose onto the barbs, then tighten the clamps down snug. If the hose is stiff from cold weather, warming it up makes installation easier.
Reviews
There are no reviews yet.